pay attention to the use of pipe cutting machine production
Ji'nan Tongri Paper cone Equipment Co.,Ltd
1. Spindle speed must be adjusted after turning off of the
machine. The transmission gear should be fully meshed. Machine is not normal at
any time, then we should immediately stop and check.
2. Before cutting, we
should adjust cutting tool, to ensure it clamping the working staff closely. The
length of the clamping part is not less than 50 mm. Parking baffle should be
fixed. After the sequential test of clamping, loosen, forward, backward , it
can work.
3. When machine tool is in the rotation, any part of your body
cannot contact any transmission part. During the operation, tie the cuffs and
wear no gloves. The head should deviate from the direction of cutting.
4.
when Exchanging tools, measuring, lubrication and cleaning pipe head, you must
stop the machine.
5. When cutting pipe head, prevent the pipe head flying out
to hurt people.
6. When putting long tubes into the rack and loosening the
binding wire, measures should be taken to prevent the rolling pressure, shocking
and hurting people .
7. When using grinding wheel in pipe cutting machine,
you should checked whether the grinding wheel is without damage or damp. And
whether the power line is reliable.
8. When the dust removal device is in
good condition, cutting operation can be performed.
9. On the direction of
feeding should stand no person.
A professional manufacturer of paper cone machine
- Pre：the application extension of p 2020/1/5
- Next：Paper cone machine meet the ne 2014/6/8
